KNIPEX CABLE SHEARS WITH TWIN CUTTING EDGE

	Initial cut: using the front cutting edge to cut the insulating sheath on larger cable diameters leaves an ergonomic handle opening width.
	Final cut: after cutting the sheath in the front profile the conductors in the rear part are cut. Initial cut in the front profile, final cut in the rear profile – to keep it as easy as possible.

Description

• For cutting copper and aluminium cables
• Not suitable for steel wire and hard drawn copper conductors
• Precision ground, hardened blades
• Clean and smooth cut without crushing and deformation
• By dividing the cutting actions into initial cut (insulating sheath in the front cutting area) and final cut (conductor in the back cutting area), cables up to Ø 20 mm can be cut in one-hand operation
• Less effort required due to favourable lever ratio and optimised cutting-edge geometry
• Guard prevents operators’ fingers being pinched
• Adjustable bolted joint, self-retaining screw
• High-grade special tool steel, forged, oil-hardened